GRAPHTEC IS200 PRO LC DRIVER

To prevent soiling, store it in its special storage box. Flashes when a document is detected during the selftest when the scanner is turned on; when scanning is suspended by pressing the STOP key; when a paper jam is detected; or when the document length is shorter than the specified scan length. The windows shown are those for Windows The symbol indicates imperative action that must be performed. The document scanned was creased or curled. Screw B Screw B Screw A Screw A Frame 3 7 2—6 Always ensure that you remove the cushion material that is included below the document hold-down unit before using the product. The following should never be attempted:

Uploader:	Takasa
Date Added:	6 March 2008
File Size:	65.12 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	49798
Price:	Free* [*Free Regsitration Required]

Cursor lines red Align with the printed lines, then click. The scanning conditions set were inappropriate for the document. Correct operation is not guaranteed when the scanner is connected to a USB port that is not the standard built-in computer port. If there is no discrepancy, color correction is complete. Please be sure to observe them strictly. This category provides information that, if ignored, is highly likely to cause fatal or serious injury to the operator. If the document becomes jammed.

Click the Close pto.

Graphtec Is200 Pro LC 42 Inch Wide Large Format Document Scanner Is200-11en-pro

Flashes while image data is being scanned. Control panel Use the keys to operate graphttec scanner and the LEDs to monitor the operating status. Click the [Finish] button. Insert the color correction sheet in the scanner as instructed. Adjust the color using the color-correction function graphtef the driver software provided. Always lift the unit by holding the underside.

Document support wire end Hidden slot on the lower level 3 Insert the center part of the document support wire into the elongated slot. One adjustment method is to make similar colors all the same color. Click [Yes] to continue the installation. Repair work by inexperienced personnel is extremely dangerous.

Remedy Documents with a glossy surface should be scanned traphtec placing them inside the carrier sheet provided. Trademarks Windows is a U.

To prevent soiling, store it in its special storage box. Scanning may be affected if the underside of the document hold-down unit becomes scratched or dirty. Remedy An internal error has occurred. Turn off its power and graphted its power cord from the electrical socket.

The scanner name displayed in the windows is the name of the scanner connected to the computer CS is used in this section. The adjustment function must be set up when a scanned drawing needs to approximate the accuracy of the original drawing closely.

Graphtec Is Pro LC 42 Inch Wide Large Format Document Scanner Isen-pro | eBay

In such cases, you should support the document with your hand when you insert it into the scanner, or try lowering the scanning speed, or both. Conventions Used in This Manual To promote safe and accurate use of the Image Scanner as well as to prevent human injury and property damage, safety precautions provided in this manual are ranked into the three categories described below.

Accidentally switching off the scanner may result in damage that requires servicing. Document guides Document-scanning table The above illustration is of the CS model. The end of the document is not scanned.

As with the first end, insert the other end of the wire so that it fits into the hidden slot on the lower level. Ethernet connector Used to connect the Ethernet cable.

Graphtec IS Pro

Insert the calibration sheet into the scanner as instructed. Check the calibration sheet for dust and dirt, then click the [Execute] button. Securely insert the power plug into the socket Prohibited Beware of electrical oro When the scanner will not be used for an extended period, unplug its power cord from the electrical socket.

Make sure that your scanner is properly grounded.